Rockford Chiropractor - NUCCA Electronics

The expose button on my X-Ray machine was shorting out and giving me bad films. So I decided to fix it.
I got the buttons from the manufacturer (great guys at GTR Labs), and opened up the control panel. This is what it looks like inside.
There's just a little circuit board with nine screws holding it.

1st Step - remove the nine screws. Simple, you graduated from 8th grade, what could be so hard about it?

Then remove the two ribbons attached to the circuit board. They have plastic connectors that wiggle out easily.



You can see here the expose button, the blue button, reflected in the mirror, and on this side, the four prongs of that button poking through the circuit board. These are soldered on. It's not like your atlas, which can get bumped out of position.






















This is soldering braid for soaking up the old solder. This part takes patience, just like the healing process, in which we set things right and then wait for the healing process to ensue. You also need a steady hand, just like when we adjust the atlas, there is a very small tolerance for error.





You may need to set the soldering iron on all four prongs, getting them hot enough so the little bit of solder still in the hole melts enough to wiggle the entire button loose. Then it takes about 30 seconds to solder the new button on.



Then you set the board back into the plastic housing, replace the nine screws and the connectors to the two ribbons, replace the back of the control panel, and setting it up, you test it.

The new button works fine with a nice little spring in it. No shorting out!

You can be your own electronics repairman now. Go ahead, what could be so hard about it? You graduated from 8th grade! Just remember, you cannot be your own NUCCA doctor. You have to get checked to be sure the "Status of the Atlas" is good. If it's not, you're going to "short out."

So what's more fun, electronics or correcting the imbalanced spine? Well, with electronics, you replace the part and release your machine into "wellness."

 With correcting the imbalanced spine, you get to see a smile grow from inside a person as they heal. If there are lots of levels of health problems, it may take some time, and nobody likes a complainer. But releasing a person's life into wellness touches many, many lives. That's a satisfying thought.

1st Step Chiropractic, the 1st Step to take in Wellness Care.